DSL Interface Cards
Connecting a DSL Interface Card to the Network
11
OL-12846-01
Step 3 Connect the other end to the wall jack (RJ-11) at your site, as shown in Figure 68.
Figure 68 Connecting an ADSL Card to the Wall Jack
Alternately, when connecting a G.SHDSL card to a 4-wire patch panel, use a Y-cable as shown in
Figure 69.
Figure 69 Connecting a G.SHDSL Card to a Patch Panel With a Y-Cable
Step 4 Turn on power to the router.
Step 5 To connect the card to the network, you must configure the DSL interface card in the router to the no
shutdown state. Enter the no shut command in the router configuration. Verify that the CD LED comes
on, indicating that the interface card is connected to the network.
Note Step 5 does not apply to the WIC-1SHDSL-V2 or WIC-1SHDSL-V3.
RJ-11
wall jack
37701
SEE MANUAL
BEFORE INSTALLATION
C
DLP OK
ADSL port
(RJ-11)
AD
SL
RJ-11 twisted-pair cable
S
H
D
S
L
S
E
E
M
A
N
U
A
L
B
E
F
O
R
E
IN
S
T
A
L
L
A
T
IO
N
C
D
L
P
O
K
W
IC
1SHDSL V2
103235
RJ-11
twisted-pair
cables
14
13
12
11
10
SHDSL port
(RJ-11)
Patch panel
To Next Page
Loading...
