DSL Interface Cards
ADSL WICs
2
OL-12846-01
Note The term dying gasp refers to power status as defined in ITU-T standard G.991.2, section 7.1.2.5.3.
LEDs on ADSL WICs
ADSL WICs have three LEDs, which are shown in Figure 62 and are described in Table 14.
Figure 62 ADSL and G.SHDSL WIC Front Panels
Supported Platforms
For a list of the platforms supported by a Cisco interface card refer to Platform Support for Cisco
Interface Cards.
Finding Support Information for Platforms and Cisco IOS Software Images
Use Cisco Feature Navigator to find information about platform support and Cisco IOS software image
support. Access Cisco Feature Navigator at http://www.cisco.com/go/fn. You must have an account on
Cisco.com. If you do not have an account or have forgotten your username or password, click Cancel at
the login dialog box and follow the instructions that appear.
Table 14 ADSL WIC LEDs
LED Color Description
CD LED Green Lit when the unit is connected to the network and operating normally. On
ADSL interface cards only, this LED blinks while training with DSLAMs.
Does not apply to the WIC-1SHDSL-V2 or WIC-1SHDSL-V3 interface cards.
LP LED Yellow DSL interface is in loopback mode.
Off Normal operation.
OK LED Green Enabled when the card is detected by the router.
LINK
(CD) LED
Green
and
Yell ow
Green when cells or frames are passing between the host and the DSLAM.
Yellow when the T1E1 framer detects an alarm. Applies only to the
WIC-1SHDSL-V2 and WIC-1SHDSL-V3 interface cards.
SEE MANUAL
BEFORE INSTALLATION
WIC
1SHDSL
CD LP OK
SEE MANUAL
BEFORE INSTALLATION
WIC
1ADSL
CD LP OK
ADSL
WIC
1ADSL IDG
ADSL
ADSL SHDSL
SEE MANUAL
BEFORE INSTALLATION
CD LP OK
WIC
1SHDSL V2
SHDSL
SEE MANUAL
BEFORE INSTALLATION
LINK LP OK
WIC
1ADSL DG
ADSL
SEE MANUAL
BEFORE INSTALLATION
CD LP OK
95231
To Next Page
Loading...
