Cisco 1601 - Router - EN - Cabling for Cisco Interface Cards

Cisco Interface Cards for Cisco Access Routers
Cabling for Cisco Interface Cards
12
OL-12796-01
Cabling for Cisco Interface Cards
The cables required to connect the interface card to the network differ according to interface and
connector type. See Table 2 for more information.
Note Cabling for 1- or 2-slot network modules is determined by the installed interface cards.
Note For network-end connectors and pinout specifications of the cables connecting the voice cards, refer to
the Cisco Modular Access Router Specifications. Look under the type of interface card.
Table 2 Cabling for Cisco Interface Cards
Technology
Connection Type
Connector Type, Cable
Color Cable Use with
Analog Dialup
300 bps to 33.6 kbps
analog dialup
RJ-11, pink RJ-11 straight-through WIC-1AM
WIC-2AM
WIC-1AM-V2
WIC-2AM-V2
Cable Modem
Cable F CATV coaxial HWIC-CABLE-D-2
HWIC-CABLE-E/J-2
DSL
ADSL RJ-11C/CA11A,
lavender
RJ-11 straight-through WIC-1ADSL
WIC-1ADSL-DG
WIC-1ADSL-I-DG
HWIC-1ADSL
HWIC-1ADSLI
SHDSL RJ-11C/CA11A,
lavender
RJ-11 straight-through for 2-wire
RJ-14 straight-through for 4-wire
WIC-1SHDSL
WIC-1SHDSL-V2
WIC-1SHDSL-V3
RJ-11 RJ-11 straight-through HWIC-2SHDSL
RJ-45 RJ-45 straight-through HWIC-4SHDSL
Ethernet
Fast Ethernet, copper RJ-45 100BASE-T Category 5 or above UTP WIC-4ESW
HWIC-4ESW
HWIC-4ESW-POE
HWIC-D-9ESW
HWIC-D-9ESW-POE
Fast Ethernet, copper RJ-45
• For 10BASE-T operation, use
Category 3, 4, or 5 UTP cable.
• For 100BASE-TX operation, use
Category 5 UTP cable.
HWIC-1FE
HWIC-2FE