Cisco Interface Cards for Cisco Access Routers
Cisco IOS Software Releases and Cisco Interface Cards
10
OL-12796-01
Cisco IOS Software Releases and Cisco Interface Cards
Cisco interface cards are often supported on multiple Cisco IOS releases. Cisco IOS release information
is documented in the product data sheet and in Feature Navigator II.
To determine which Cisco IOS releases support your particular router and combination of cards and
modules, go to the Software Advisor at http://tools.cisco.com/Support/Fusion/.
You must have an account on Cisco.com. If you do not have an account or have forgotten your username
or password, click Cancel at the login dialog box and follow the instructions that appear.
Cisco 3800 series 4 Single-wide Slot 0 through
slot 3
–
2 Double-wide Slot 1, slot 3 Removing the slot divider changes slot numbering
as follows:
• Slot 0 and slot 1 become slot 1
• Slot 2 and slot 3 become slot 3
Tip To install double-wide interface cards,
remove the slot divider (see the “Installing
Double-Wide Interface Cards” section in
Installing Cisco Interface Cards in Cisco
Access Routers).
Cisco ICS 7750 – – – Routers do not support HWICs.
To install interface cards in the Cisco ICS 7750,
use a multiroute processor (MRP) or analog station
interface 81 (ASI 81) card.
Tip Refer to the “Processor Cards Feature
Summary” chapter in the Cisco ICS 7750
System Description document for more
information about these cards.
Cisco MWR 1941-DC
routers
1 Single-wide Slot 1 through
slot 3
Routers do not support HWICs.
Table 1 Interface Card Slots Available on Cisco Access Routers (continued)
Cisco Router
Number
of Slots Slot Type Slot Numbering Installation Notes and Limitations
To Next Page
Loading...
