Cisco Interface Cards for Cisco Access Routers
Cabling for Cisco Interface Cards
13
OL-12796-01
Gigabit Ethernet,
copper
RJ-45 1000BASE-T Category 5 or above UTP HWIC-1GE-SFP (through
SFP)
Gigabit Ethernet,
optical
Note A single fiber
link should not
mix 62.5- and
50-micron
cable.
LC, color according to
optical wavelength
Optical fiber as specified on applicable
data sheet
ISDN Connections
BRI S/T
(external NT1)
RJ-48C RJ-48C straight-through WIC36-1B-S/T
WIC-1B-S/T
WIC-1B-S/T-V3
WIC-1B-S/T-LL
BRI S/T
(external NT1)
RJ-45 RJ-45 Straight-through HWIC-ADSL-B/ST
HWIC-ADSLI-B/ST
BRI U
(built-in NT1)
RJ-49C/CA-A11, red RJ-11; RJ-21 if using NM-HDA,
straight-through
WIC36-1B-U
WIC-1B-U
WIC-1B-U-V2
56/64 kbps DSU/CSU 8-pin modular, blue RJ-48S straight-through WIC-1DSU-56K4
T1/fractional T1
DSU/CSU
RJ-48C RJ-48C straight-through WIC-1DSU-T1
WIC-1DSU-T1-V2
Serial Connections
Synchronous serial 60-pin D, blue Serial transition cable (EIA/TIA-232,
EIA/TIA-449, EIA/TIA-530 DTE, V.35,
X.21, NRZ/NRZI)
WIC-1T
Serial 26-pin Cisco Smart
serial
Cisco Smart serial interface cable (see
Table 3)
HWIC-4A/S
HWIC-4T
WIC-2A/S
WIC-2T
68-pin Cisco 4-port RS-232 DCE or DTE cable
assembly (two cable assemblies are
required for each HWIC-8A/S-RS232)
HWIC-8A/S-RS232
Cisco 8-port RS-232 DTE cable assembly
(two cable assemblies are required for
each HWIC-16A)
HWIC-8A
HWIC-16A
Table 2 Cabling for Cisco Interface Cards
Technology
Connection Type
Connector Type, Cable
Color Cable Use with
To Next Page
Loading...
