LAN Interface Cards
WIC-1ENET Interface Card
4
OL-12849-01
• Voice VLANs
• General Attribute Registration Protocol (GARP), GARP Multicast Registration Protocol (GMRP),
and GARP VLAN Registration Protocol (GVRP)
• Cisco Inter-Switch Link (ISL) tagging (the chip does not support ISL)
• Layer 3 on-board switching
• Monitoring of VLANs
• Multi-VLAN ports network port
• Shared STP instances
• VLAN-based SPAN
• VLAN Query Protocol (VQP)
• VTP pruning protocol
• Web-based management interface
• Remote Monitoring (RMON)
WIC-1ENET Interface Card
This section describes how to connect the Cisco 1-port Ethernet interface card supporting 10BASE-T
Ethernet (WIC-1ENET), and contains the following sections:
• WIC-1ENET Interface Card LED, page 4
• WIC-1ENET Requirements, page 5
• WIC-1ENET Full-Duplex and Half-Duplex, page 6
The 1-port Ethernet interface card provides the router with additional Ethernet interfaces that can use
the functionality of the Cisco IOS software with any type of external broadband modem, such as a cable
modem, or xDSL modem.
Figure 108 shows the WIC-1ENET interface card.
Figure 108 WIC-1ENET Interface Card
WIC-1ENET Interface Card LED
The LNK (physical layer link) LED is on when the Cisco IOS software recognizes the WIC-1ENET card
and the connection is up. The FDX LED is on when the port is operating in full-duplex mode, and off
when operating in half-duplex mode. Additionally, the Activity LED on the front of the router indicates
that data is being transmitted or received on the slot.
WIC
1ENET
FDX
SEE MANUAL
BEFORE
INSTALLATION
LNK
10BT ETHERNET
45789
To Next Page
Loading...
