Cisco 1601 - Router - EN - Page 214

T1/E1 High-Speed WAN Interface Cards
Connecting a T1/E1 HWIC to a Network
12
OL-12851-01
Connecting a T1/E1 HWIC to a Network
Use straight-through RJ-48C-to-RJ-48C cables to connect T1/E1 ports to RJ-48C jacks. See the Cisco
Modular Access Router Cable Specifications for pinouts.
To connect a T1/E1 port to the network, complete the following steps:
Step 1 Connect one end of the cable to a T1/E1 port on the card.
Step 2 Connect the other end to the RJ-48C jack at your site, as shown in Figure 0-141.
Figure 0-141 Connecting a T1/E1 HWIC to an RJ-48C Jack
Additional References
For additional information, see the following documents and resources.
HWIC-
4T1/E1
CD/LP P3 AL
CD/LP
P2 AL
CD/LP P1 AL
CD/LP P0 AL
170625
RJ-48C jack
T
1/E1 port (RJ-48C)
Straight-through
RJ-48C-to-RJ-48C
cable
Related Topic Document Title
Regulatory compliance and safety
information
Cisco Network Modules and Interface Cards Regulatory Compliance and Safety
Information
Cisco IOS software website and reference
documentation
Cisco IOS Software
http://www.cisco.com/en/US/products/sw/iosswrel/tsd_products_support_cate
gory_home.html
Technical documentation, including
feedback and assistance
What’s New in Cisco Product Documentation (including monthly listings of new
and revised documents) at
http://www.cisco.com/univercd/cc/td/doc/abtunicd/136957.htm