Cisco 1601 - Router - EN - Page 51

Installing Cisco Interface Cards in Cisco Access Routers
Installing Cisco Interface Cards in Cisco Network Modules
19
OL-12842-01
Step 3 Using a number 1 Phillips or flat-blade screwdriver, loosen the screws on the blank interface card
faceplate. (See Figure 27.) Remove the blank faceplate.
Figure 27 Blank Interface Card Faceplate
Tip Save blank interface card faceplates for future use.
Step 4 Align the interface card with the guides in the slot on the network module and slide it gently into place
until the edge connector is seated into the connector on the module. (See Figure 28.)
Figure 28 Installing an Interface Card in a Network Module (Typical)
Step 5
Using a number 1 Phillips or flat-blade screwdriver, tighten the captive mounting screws into the holes
on the network module faceplate.
Step 6 Reinstall the network interface cables and power up the router.
The following warning applies to routers that use a DC power supply:
Warning After wiring the DC power supply, remove the tape from the circuit breaker switch handle and
reinstate power by moving the handle of the circuit breaker to the ON position. Statement 8
DO NOT INSTALL WAN INTERFACE
CARDS WITH POWER APPLIED
H6649
1 Interface card 2 2-slot network module
2
E
2
W
W
1
E
T
H
1
E
T
H
E
R
N
E
T
0
A
U
I
E
N
ACT
LNK
ACT
LNK
B
R
I
S
/T
B
1
B
2
WO
H7219
1
2