Cisco 1800 Series Configuring

Configuring Radio Settings on an Access Point
How to Configure Radio Settings on an Access Point
25
Configuring Packet Fragmentation Threshold on an Access Point
Perform this task to configure the size at which packets are fragmented (sent as several pieces instead of
as one block).
Use a low setting in areas where communication is poor or where there is a great deal of radio
interference.
SUMMARY STEPS
1. enable
2. configure terminal
3. interface dot11Radio interface
4. fragment-threshold bytes
5. end
6. copy running-config startup-config

Cisco 1800 Series Specifications

General

Category	Network Router
Performance	Varies by model
Form Factor	Desktop
Connectivity Technology	Wired
Remote Management Protocol	SNMP, Telnet, HTTP, HTTPS
Dimensions	Varies by model
Weight	Varies by model
Model	1800 Series
Interfaces	Ethernet, Fast Ethernet, Serial, ISDN
Routing Protocols	RIP, OSPF, EIGRP, BGP
Security	Firewall, VPN, ACLs
Data Link Protocol	Ethernet, Fast Ethernet, Serial, Frame Relay
Network / Transport Protocol	TCP/IP
Features	Quality of Service (QoS), VLAN support, DHCP server
RAM	Varies by model
Flash Memory	Varies by model
Power Supply	Internal AC power supply
Operating Temperature	0 to 40 °C (32 to 104 °F)
Storage Temperature	-4°F to 149°F (-20°C to 65°C)