Cisco 1800 Series Configuring

Configuring Radio Settings on an Access Point
How to Configure Radio Settings on an Access Point
21
Configuring Beacon Period and DTIM on an Access Point
Perform this task to configure the beacon period and delivery traffic indication message (DTIM).
The beacon period is the amount of time between AP beacons in Kilo microseconds. One
kilomicrosecond equals 1,024 microseconds. The Data Beacon Rate, always a multiple of the beacon
period, determines how often the beacon contains a DTIM. The DTIM tells power-save client devices
that a packet is waiting for them.
For example, if the beacon period is set at 100, its default setting, and the data beacon rate is set at 2, its
default setting, then the AP sends a beacon containing a DTIM every 200 kilomicroseconds.
The default beacon period is 100, and the default DTIM is 2.
SUMMARY STEPS
1. enable
2. configure terminal
3. interface dot11Radio interface
4. beacon {period microseconds | dtim-period period-count}
5. end
6. copy running-config startup-config

Cisco 1800 Series Specifications

General

Category	Network Router
Performance	Varies by model
Form Factor	Desktop
Connectivity Technology	Wired
Remote Management Protocol	SNMP, Telnet, HTTP, HTTPS
Dimensions	Varies by model
Weight	Varies by model
Model	1800 Series
Interfaces	Ethernet, Fast Ethernet, Serial, ISDN
Routing Protocols	RIP, OSPF, EIGRP, BGP
Security	Firewall, VPN, ACLs
Data Link Protocol	Ethernet, Fast Ethernet, Serial, Frame Relay
Network / Transport Protocol	TCP/IP
Features	Quality of Service (QoS), VLAN support, DHCP server
RAM	Varies by model
Flash Memory	Varies by model
Power Supply	Internal AC power supply
Operating Temperature	0 to 40 °C (32 to 104 °F)
Storage Temperature	-4°F to 149°F (-20°C to 65°C)