Spectralink VIEW Certified Configuration Guide: Cisco Controllers and APs
721-1001-000-AH.docx
December 2016 16
to hand out leases to the connected clients. (Note: The WLC’s DHCP server does not lease
addresses to the AP.) The instructions for doing so are included at the end of this document.
1 From the main menu, click Controller.
2 In the navigation pane, click Interfaces. Verify that the proper IP addresses are
assigned to the interfaces.
3 Under Interface Name click management. Note: the screenshot is from a Cisco 5500.
7.4 and later versions provide redundancy management and redundancy port entries.
7.6 and later versions support a virtual interface entry. If the interface is not present on
the model being configured, no values need to be entered.
4 Under DHCP Information, enter the IP address of the Primary DHCP Server.
5 Repeat this step for the ap-manager interface, if present on the model configured.
6 Click the Apply button and save the changes.
To Next Page
Loading...
