Cisco 2500 Series Configuration Guide

Spectralink VIEW Certified Configuration Guide: Cisco Controllers and APs
721-1001-000-AH.docx
December 2016 34
RRM parameters
In the navigation pane under 802.11a/n(/ac), click RRM. Set RRM parameters as follows:
1 Click TPC. Set the Tx Power Level Assignment Algorithm to Fixed. (The Invoke
Power Update Once/On Demand setting may be deployed occasionally to allow the
Cisco network to self-configure at a time of low usage.) Note that the individual AP
assignments shown in 2 in this section override the Fixed power level set here.
2 Click DCA. Set the Channel Assignment Method to OFF. (The Freeze/Invoke
Channel Update Once setting may be deployed occasionally to allow the Cisco network
to self-configure at a time of low usage.) In the DCA Channel list, enter all channels
desired by the facility channel use plan, appropriate to the regulatory domain, and
supported by the regulatory domain settings of the handsets.

Cisco 2500 Series Specifications

General

Brand	Cisco
Model	2500 Series
Category	Controller
Language	English