Cisco 2901 - Page 55

47
Cisco 3900 Series, Cisco 2900 Series, and Cisco 1900 Series Integrated Services Routers Generation 2 Software Configuration Guide
Chapter Configuring Ethernet CFM and Y.1731 Performance Monitoring on Layer 3 Interfaces
CFM Support on Routed Port and Port MEP
No customer Down Gi0/2 100
customer1101 N/A Static
N/A
400 enterprise 6 70ca.9b4d.a400 Vlan I
No enterprise Down Gi0/1 110
custservice N/A Static
N/A
44 carrier 2 70ca.9b4d.a400 Vlan N
No carrier Down Gi0/2 200
carrier N/A Static
N/A
Total Local MEPs: 3
Local MIPs: None
Router#
Use the show ethernet cfm maintenance-points remote command to display information about remote
maintenance point domains or levels.
The following example displays the continuity check messages exchanged between remote MEPs:
On router 1:
Router1#show ethernet cfm maintenance-points remote
-----------------------------------------------------------------------------------------
MPID Domain Name MacAddress IfSt PtSt
Lvl Domain Ingress
RDI MA Type Id SrvcInst
EVC Name Age
Local MEP Info
-----------------------------------------------------------------------------------------
110 customer 70ca.9b4d.a400 Up Up
7 customer Gi0/2
- customer1101 Vlan 100 N/A
N/A 12s
MPID: 100 Domain: customer MA: customer1101
410 enterprise 70ca.9b4d.a400 Up Up
6 enterprise Gi0/1
- custservice Vlan 110 N/A
N/A 12s
MPID: 400 Domain: enterprise MA: custservice
43 carrier 70ca.9b4d.a400 Up Up
2 carrier Gi0/2
- carrier Vlan 200 N/A
N/A 12s
MPID: 44 Domain: carrier MA: carrier
Total Remote MEPs: 3
Router1#
On router 2:
Router2#show ethernet cfm maintenance-points remote
-----------------------------------------------------------------------------------------
MPID Domain Name MacAddress IfSt PtSt
Lvl Domain Ingress
RDI MA Type Id SrvcInst
EVC Name Age
Local MEP Info
-----------------------------------------------------------------------------------------