Cisco 3000 Series User Manual

Installing
on Wall
DnstaUng
on
Wall
When
choosing
the wall
on
which to mount the
chassis
consider cable
lengths
and limitations and
wall structure To install the
system
on
wall proceed as
follows
Note
The bracket
mounting points
are not
wide
enough
to
accommodate the 16 16
spacing
commonly
used for wall studs
boards
Mount
piece
of
plywood
minimum
16
16
1/2
on the
wall
then
mount
the bracket
to
the
plywood
Ensure
that the chassis is anchored to solid
wood
Step
Position the chassis
against
the
board
as shown
in
Figure
3-4 Use the lower of each
pair
of
keyhole
cutouts on the
mounting
bracket to mark
the
drilling points
Holes
Angled
side
Back
Front
Figure
3-3 Position of
Mounting
flrackets
on
Router
Chassis front
3-4 Cisco 3000 Hardware Installation and Maintenance

Cisco 3000 Series Specifications

General

Model	Cisco 3000 Series
Ports	Varies by model
Switching Capacity	Up to 176 Gbps
Power Supply	Internal or external, varies by model
Layer Support	Layer 2 and Layer 3
Power over Ethernet	PoE or PoE+
Memory	Varies by model
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	0° to 45°C (32° to 113°F)
Operating Humidity	10% to 85% non-condensing
Uplink Interfaces	Optional 1G/10G SFP/SFP+ or 10GBase-T