Cisco 3100 Series - Power Cord Specifications

CommentsPIDOptics Type
Length 1, 1.5, 2, 2.5, 3, 4, 5 m
You must set the link
partner transmit
strength to 400mV or
greater.
Note
SFP-H10GB-CUxM10G DAC copper
Length 7, 10 mSFP-H10GB-ACUxM10G DAC CU active
Length 1, 2, 3, 5, 7, 10 mSFP-10G-AOCxM10G AOC
The following table lists the supported transceivers for the fixed ports on the Secure Firewall 3130 and 3140,
and the FPR3K-XNM-8X25G network module.
Table 6: Supported 25-Gb SFP Transceivers
CommentsPIDOptics Type
—SFP-25G-SR-S25G-SR
Dual rate, longer reachSFP-10/25G-CSR-S25G-CSR
Dual rateSFP-10/25G-LR-S25G-LR
Length 1, 1.5, 2, 2.5, 3, 4, 5 mSFP-H25G-CUxM25G DAC copper
Length 1, 2, 3, 4, 5, 7, 10 mSFP-25G-AOCxM25G AOC
The following table lists the supported transceivers for the FPR-X-NM-4X40G network module.
Table 7: Supported 40-Gb SFP Transceivers for FPR-X-NM-4X40G
CommentsPIDOptics Type
—QSFP-40G-SR440G-SR4
Ethernet onlyQSFP-40G-SR4-S40G-SR4-S
300 m with OM3QSFP-40G-CSR440G-CSR4
LC connectorQSFP-40G-SR-BD40G-SR-BD
Ethernet onlyQSFP-40G-LR4-S40G-LR4-S
Ethernet and OTU3QSFP-40G-LR440G-LR4
LR4 Lite, up to 2 kmWSP-Q40GLR4L40G-LR4L
QSFP to QSFP copper direct-attach
cables (passive); length 1, 3, 5 m
Cisco QSFP-H40G-CUxM40G-CU
Cisco Secure Firewall 3100 Series Hardware Installation Guide
31
Overview
Supported SFP/SFP+/QSFP+ Transceivers