Connect the DC Power Supply Module
The input connector and plug must be UL recognized under UL 486 for field wiring. The connection polarity
is from left to right: negative (–), positive (+), and ground.
Use the handle on the power supply installation and removal. You must support the module with one hand
because of its length.
Figure 50: DC Power Supply Module
FAIL and OK LEDs2Handle1
Ejector latch4DC power connector3
Safety Warnings
Take note of the following warnings:
Statement 1030—Equipment Installation
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Warning
Statement 1073—No User-Serviceable Parts
There are no serviceable parts inside. To avoid risk of electric shock, do not open.
Warning
Cisco Secure Firewall 3100 Series Hardware Installation Guide
74
Installation, Maintenance, and Upgrade
Connect the DC Power Supply Module
To Next Page
Loading...
