Cisco 3600 Series Hardware Installation Guide

CHAPTER
3-1
Cisco 3600 Series Routers Hardware Installation Guide
OL-2056-05
3
Installing the Router
This chapter describes how to install your Cisco 3600 series router and connect it to networks and
external devices. It contains the following sections:
• Installing Modules, Interface Cards, and Power Supplies, page 3-2
• Installing the Chassis, page 3-3
• Installing Chassis Ground Connection, page 3-19
• Power Connections, page 3-27
• Connecting WAN, LAN, and Voice Cables, page 3-37
• Connecting to a Console Terminal or Modem, page 3-43
• Powering Up the Router, page 3-51
• Configuring the Router, page 3-53
Warning Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
Warning This unit is intended for installation in restricted access areas. A restricted access area can be
accessed only through the use of a special tool, lock and key, or other means of security.
Statement 1017
Note See the “Tools and Equipment for Installation and Maintenance” section on page 2-8 for a list of tools
and equipment that might be required for your installation.

Cisco 3600 Series Specifications

General

Operating System	Cisco IOS
Series	3600
Type	Modular Router
Interfaces	Ethernet, Fast Ethernet, Serial, ISDN
Routing Protocols	RIP, OSPF, EIGRP, BGP, IS-IS
Redundancy	Optional redundant power supply
Management	CLI, SNMP, Telnet
Weight	Varies depending on the specific model
Power Supply	AC or DC, optional redundant power supply