Chapter 3 Switch Installation
Installing the Switch
3-32
Catalyst 3750 Switch Hardware Installation Guide
78-15136-01
Figure 3-30 Attaching the RPS Connector Cover on the Catalyst 3750-24TS, 3750G-24T, and the
3750-48TS Switches
Mounting the Switch on a Wall
For the best support of the switch and cables, make sure the switch is attached
securely to wall studs or to a firmly attached plywood mounting backboard.
Mount the switch with the front panel facing up, as shown in Figure 3-31.
Warning
To comply with safety regulations, mount the switches on a wall with the front
panel facing up.
1 Phillips pan-head screws
2 RPS connector cover
3 RPS connector
RATING
100-200V ~
1.6A-0>9A, 50-60 HZ
DC INPUTS FOR REMOTE
POWER SUPPLY
SPECIFIED IN MANUAL
+12v @8.5a
CONSOLE
STACK 1
STACK 2
21 3
86572
To Next Page
Loading...
