Cisco 3750 - Attaching the Cable Guide

Chapter 3 Switch Installation
Installing the Switch
3-28
Catalyst 3750 Switch Hardware Installation Guide
78-15136-01
To use the CLI, enter commands at the Switch> prompt through the console port
by using a terminal program or through the network by using Telnet. For
configuration information, refer to the switch software configuration guide or the
switch command reference. To use CMS, go to the “Accessing the Switch from
Your Browser” section on page 1-13.
Attaching the Cable Guide
We recommend attaching the cable guide to prevent the cables from obscuring the
front panel of the switch and the other devices installed in the rack. Use the
supplied black screw, as shown in Figure 3-26 and Figure 3-27 to attach the cable
guide to the left or right bracket.
Figure 3-26 Attaching the Cable Guide on the Catalyst 3750-24TS, 3750G-24T, and 3750G-24TS
Switches
Note The Catalyst 3750-48 switch ships with a special cable guide, as shown in
Figure 3-27. This cable guide secures up to 48 cables. Use the supplied black
screw to mount it on the left bracket.
1 Cable guide screws
Catalyst 3750
SERIES
SYST
RPS
MASTR
STAT
DUPLX
SPEED
STACK
MODE
13X
14X
23X
24X
1X
2X
11X
12X
25
26
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
1
86568