Cisco 3750 - Page 9

3-9
Catalyst 3750 Switch Hardware Installation Guide
78-15136-01
Chapter 3 Switch Installation
Preparing for Installation
• No parity
• None (flow control)
After you have gained access to the switch, you can change the console baud rate
through the Administration > Console Baud Rate window in the Cluster
Management Suite (CMS).
Step 2 Using the supplied RJ-45-to-DB-9 adapter cable, insert the RJ-45 connector into
the console port, as shown in Figure 3-1.
Step 3 Attach the DB-9 female DTE adapter of the RJ-45-to-DB-9 adapter cable to a PC,
or attach an appropriate adapter to the terminal.
Step 4 Start the terminal-emulation program if you are using a PC or terminal.
Figure 3-1 Connecting to the Console Port
1 Console port
CONSOLE
STACK 1
STACK 2
86685
1