Installing Blank Faceplates
60
Installing Network Modules in Cisco 3800 Series Routers
OL-5973-01
Removing Slot Adapters
To remove a slot adapter, use a number 2 Phillips screwdriver to loosen the captive thumbscrew. Pull
the slot adapter straight out of the slot.
Tip Save the slot adapter for future use.
Installing Blank Faceplates
All network module slots must be covered by network module faceplates, blank faceplates, or slot
adapters for cooling, electromagnetic interference (EMI) reduction, and safety. The network module
hardware kit for Cisco 3800 series routers contains four blank faceplates. Each blank faceplate covers
one standard single-wide network module slot.
Warning
Blank faceplates and cover panels serve three important functions: they prevent exposure to
hazardous voltages and currents inside the chassis; they contain electromagnetic interference (EMI)
that might disrupt other equipment; and they direct the flow of cooling air through the chassis. Do not
operate the system unless all cards, faceplates, front covers, and rear covers are in place.
Statement
1029
Figure 36 shows a blank faceplate for a network module slot.
Note To cover network module slots on Cisco 3800 series routers, use only the blank faceplate with captive
thumbscrews shown in Figure 36. Do not use blank faceplates with snap tabs.
Figure 36 Blank Faceplate for Standard Single-Wide Network Module Slot
To install a blank faceplate, align the captive screws with the screw holes on the router. Use a number
2Phillips screwdriver to tighten the captive screws until the faceplate is flush with the chassis. To
remove the faceplate, loosen the captive screws.
Tip Save blank faceplates for future use.
121064
To Next Page
Loading...
Need help?
General
