5-31
Cisco Unified IP Phone 6921, 6941, 6945, and 6961 Administration Guide for Cisco Unified Communications Manager 8.6 (SCCP and SIP)
OL-24567-01
Chapter
Setting up UCR 2008
Configuring UCR 2008 in Phone
Use this procedure to set the following UCR 2008 parameters:
• SSH Access
• Web Access
Step 1 Choose Device > Phone.
Step 2 Set the SSH Access parameter to Disabled.
Step 3 Set the Web Access parameter to Disabled.
Step 4 Click Save.
Configuring UCR 2008 in Common Phone Profile
Use this procedure to set the following UCR 2008 parameters:
Table 5-5 UCR 2008 parameter location
Parameter Administration Path Procedure
FIPS Mode Device > Device Settings > Common
Phone Profile
Configuring UCR 2008 in
Common Phone Profile,
page 5-31
System > Enterprise Phone Configuration Configuring UCR 2008 in
Enterprise Phone Configuration,
page 5-32
SSH Access Device > Phone Configuring UCR 2008 in Phone,
page 5-31
Device > Device Settings > Common
Phone Profile
Configuring UCR 2008 in
Common Phone Profile,
page 5-31
Web Access Device > Phone Configuring UCR 2008 in Phone,
page 5-31
80-bit SRTCP Device > Device Settings > Common
Phone Profile
Configuring UCR 2008 in
Common Phone Profile,
page 5-31
System > Enterprise Phone Configuration Configuring UCR 2008 in
Enterprise Phone Configuration,
page 5-32
IP Addressing Mode Device > Device Settings > Common
Device Configuration
Configuring UCR 2008 in
Common Device Configuration,
page 5-32
IP Addressing Mode
Preference for
Signaling
Device > Device Settings > Common
Device Configuration
Configuring UCR 2008 in
Common Device Configuration,
page 5-32