Cisco 6921 Administration Guide

5-32
Cisco Unified IP Phone 6921, 6941, 6945, and 6961 Administration Guide for Cisco Unified Communications Manager 8.6 (SCCP and SIP)
OL-24567-01
Chapter
Setting up UCR 2008
• FIPS Mode
• SSH Access
• 80-bit SRTCP
Step 1 Choose Device > Device Settings > Common Phone Profile.
Step 2 Set the FIPS Mode parameter to Enabled.
Step 3 Set the SSH Access parameter to Disabled.
Step 4 Set the 80-bit SRTCP parameter to Enabled.
Step 5 Click Save.
Configuring UCR 2008 in Enterprise Phone Configuration
Use this procedure to set the following UCR 2008 parameters:
• FIPS Mode
• 80-bit SRTCP
Step 1 Choose Device > Device Settings > Common Phone Profile.
Step 2 Set the FIPS Mode parameter to Enabled.
Step 3 Set the 80-bit SRTCP parameter to Enabled.
Step 4 Click Save.
Configuring UCR 2008 in Common Device Configuration
Use this procedure to set the following UCR 2008 parameters:
• IP Addressing Mode
• IP Addressing Mode Preference for Signaling
Step 1 Choose Device > Device Settings > Common Device Configuration.
Step 2 Set the IP Addressing Mode parameter.
Step 3 Set the IP Addressing Mode Preference for Signaling parameter.
Step 4 Click Save.

Cisco 6921 Specifications

General

Speakerphone	Yes
Headset Port	Yes
Power	IEEE 802.3af Power over Ethernet (PoE)
Lines	2
Audio Codec Support	G.711a, G.711u, G.722, G.729a, iLBC
Ethernet Ports	2
Protocols	SCCP
Weight	1 kg
Ethernet Switch	10/100BASE-T Ethernet switch