Cisco 860 User Manual

2-20
Cisco Integrated Services Router Hardware Installation Guide
Chapter 2 Installing the Router
Installing the Cisco 810 ISR
Warning This equipment must be grounded. Never defeat the ground conductor or operate the equipment
in the absence of a suitably installed ground conductor. Contact the appropriate electrical
inspection authority or an electrician if you are uncertain that suitable grounding is available.
Statement 1024
Warning Only trained and qualified personnel should be allowed to install, replace, or service this
equipment. Statement 1030
Warning No user-serviceable parts inside. Do not open. Statement 1073
Warning Ultimate disposal of this product should be handled according to all national laws and
regulations. Statement 1040
Warning Read the wall-mounting instructions carefully before beginning installation. Failure to use the
correct hardware or to follow the correct procedures could result in a hazardous situation to
people and damage to the system. Statement 378
Warning The covers are an integral part of the safety design of the product. Do not operate the unit
without the covers installed. Statement 1077
Warning Do not locate the antenna near overhead power lines or other electric light or power circuits, or
where it can come into contact with such circuits. When installing the antenna, take extreme care
not to come into contact with such circuits, because they may cause serious injury or death. For
proper installation and grounding of the antenna, please refer to national and local codes (for
example, U.S.:NFPA 70, National Electrical Code, Article 810, Canada: Canadian Electrical
Code, Section 54). Statement 1052
Warning This product is not intended to be directly connected to the Cable Distribution System.
Additional regulatory compliance and legal requirements may apply for direct connection to the
Cable Distribution System. This product may connect to the Cable Distribution System ONLY
through a device that is approved for direct connection. Statement 1078
Equipment, Tools, and Connections
This section describes the equipment, tools, and connections necessary for installing your Cisco 819
ISR. It contains the following topics:
• Items Shipped with your Router, page 2-21
• Additional Items, page 2-21
• Connections, page 2-21

Cisco 860 Specifications

General

Brand	Cisco
Model	860
Category	Cordless Telephone
Language	English