Configuring Access Node Control Protocol on Cisco ASR 9000 Series Routers
Configuration Examples for Configuring ANCP on Cisco ASR 9000 Series Routers
QC-105
Cisco ASR 9000 Series Aggregation Services Router Modular Quality of Service Configuration Guide
OL-23108-02
Configuring ANCP Server Sender Name: Example
The following example shows how to configure the ANCP local sender name:
configure
ancp server sender-name 0013.1aff.c2bd
commit
Configuring ANCP Neighbors: Example
The following example shows how to set ANCP neighbor parameters:
configure
ancp neighbor sender-name 0001.2222.3333 description VendorA-1
ancp neighbor sender-name 0001.2222.3333 adjacency-timer 20
commit
The following example shows the output from a specific neighbor using the sender-name MAC address:
show ancp neighbor sender-name 0006.2aaa.281b
ANCP Neighbor Data
-------------------------------------------
Sender Name 0006.2aaa.281b
Description first
State ESTAB
Capability Topology Discovery
Ports:
State Up 25
State Down 5
Total 30
The following example shows the same command with the addition of the detail keyword, showing a
summary of AN ports that were reported by that neighbor:
show ancp neighbor sender-name 0006.2aaa.281b detail
ANCP Neighbor Data
-------------------------------------------
Sender Name 0006.2aaa.281b
Description first
State ESTAB
Capability Topology Discovery
Ports:
State Up 4
State Down 0
Total 4
Remote IP Addr/TCP Port 209.165.200.225/11126
Local IP Addr/TCP Port 209.165.200.250/6068
Server Sender Name 0013.1aff.c2bd
Remote Timeout 25500 msec
Local Timeout 10000 msec
Adjacency Uptime 01:25:20
Time Since Last Port Msg 00:00:04
Remote Port 0
Remote Instance 1
Local Instance 1
Remote Partition ID 0
To Next Page
Loading...
Need help?
General
