Configuring Access Node Control Protocol on Cisco ASR 9000 Series Routers
Configuration Examples for Configuring ANCP on Cisco ASR 9000 Series Routers
QC-106
Cisco ASR 9000 Series Aggregation Services Router Modular Quality of Service Configuration Guide
OL-23108-02
List of AN port data for neighbor sender name 0006.2aaa.281b
------------------------------ ----- ---------- -------- ---- ------------
Line Num Adjusted DS
Circuit-id State Uptime State Intf Rate (kbps)
------------------------------ ----- ---------- -------- ---- ------------
circuit1 UP 00:27:49 SHOWTIME 3 2250
circuit2 UP 00:00:49 SHOWTIME 2 2250
circuit3 UP 00:00:49 SHOWTIME 2 2250
circuit4 UP 00:00:49 SHOWTIME 0 2250
The following example shows the same command, this time with the addition of the statistics keyword,
showing a summary of message statistics for the selected neighbor:
show ancp neighbor sender-name 0006.2aaa.281b statistics
ANCP Neighbor Message Statistics
for Sender-name -, Description 0006.2aaa.281b
-----------------------------------------------
Sent Received
SYN 1 2
SNYACK 1 0
ACK 589 238
RSTACK 0 0
Port Up - 10
Port Down - 0
Drops 0 0
Total 600 250
The following example shows how to display generic information about ANCP configuration, along with
neighbor and port counts by state:
show ancp summary
ANCP Summary Information
----------------------------------------------
Capability: Topology Discovery
Server sender-name: 0013:1aff.c2bd
Neighbor count by state:
- 0
SYNSENT 0
SUNRCVD 0
ESTAB 1
----------------------------------
Total 1
Port count by state:
State Up 1
State Down 0
State Unknown 0
----------------------------------
Total 1
No. configured ports 1
No. mapped sub-interfaces 4
The following example shows how to display rate adjustment configuration information in addition to
the generic information shown in the previous example:
show ancp summary detail
ANCP Summary Information
----------------------------------------------
Capability: Topology Discovery
To Next Page
Loading...
Need help?
General
