Cisco A9K-SIP-700 Configuring

Configuring Channelized SONET/SDH on the Cisco ASR 9000 Series Router
How to Configure Channelized SONET/SDH
HC-327
Cisco ASR 9000 Aggregation Services Router Interfaces and Hardware Component Configuration Guide
OL-26061-03
How to Configure Channelized SONET/SDH
This section contains the following procedures:
• Configuring SONET T3 and VT1.5-Mapped T1 Channels, page 327
• Configuring Packet over SONET Channels, page 332
• Configuring a Clear Channel SONET Controller for T3, page 335
• Configuring Channelized SONET APS, page 338
• Configuring SDH AU-3, page 341
• Configuring SDH AU-4, page 349
Configuring SONET T3 and VT1.5-Mapped T1 Channels
This task explains how to configure a SONET line into T3 and VT-mapped T1 Channels.
Prerequisites
• You should know how to configure the SONET controller as specified in the “How to Configure
Clear Channel SONET Controllers” section of the Configuring Clear Channel SONET Controllers
on the Cisco ASR 9000 Series Router module.
• STS paths can be channelized into T3s on the following SPAs:
– Cisco 1-Port Channelized OC-48/STM-16 SPA
– Cisco 1-Port Channelized OC-3/STM-1 SPA
– Cisco 2-Port Channelized OC-12/DS0 SPA
• STS paths can be channelized into VTG mapped T1s on the following SPA:
– Cisco 1-Port Channelized OC-3/STM-1 SPA
– Cisco 2-Port Channelized OC-12/DS0 SPA
• T3 paths can be channelized into T1s or E1s on the following SPA:
– Cisco 1-Port Channelized OC-3/STM-1 SPA
– Cisco 2-Port Channelized OC-12/DS0 SPA
• T1 paths can be channelized into NxDS0s on the Cisco 2-Port Channelized OC-12/DS0 SPA.
Restrictions
T1s and E1s are not supported on the Cisco 1-Port Channelized OC-48/STM-16 SPA.
SUMMARY STEPS
1. configure
2. controller sonet interface-path-id
3. clock source {internal | line}
4. framing sonet

Cisco A9K-SIP-700 Specifications

General

Brand	Cisco
Model	A9K-SIP-700
Category	Network Router
Language	English