Data Sheet
All contents are Copyright © 1992–2006 Cisco Systems, Inc. All rights reserved. This document is Cisco Public Information. Page 7 of 9
Item Specification
ICES-003 (Canada)
VCCI (Japan)
EN 301.489-1 and -17 (Europe)
EN 60601-1-2 EMC requirements for the Medical Directive 93/42/EEC
Security:
802.11i, WPA2, WPA
802.1X
AES, TKIP
Other:
IEEE 802.11g and IEEE 802.11a
FCC Bulletin OET-65C
RSS-102
Antenna Connectors 2.4 GHz
Dual RP-TNC connectors
5 GHz
Dual RP-TNC connectors
Status LEDs
Status LED indicates operating state, association status, error/warning condition, boot
sequence, and maintenance status.
Ethernet LED indicates status of activity over the Ethernet.
Radio LED indicates status of activity over the radio.
Dimensions
(W x L x H)
6.6 x 8.5 x 1.1 in. (16.76 x 21.59 x 2.79 cm)
Weight
2.0 lbs
Environmental
Non-operating (storage) temperature: –40 to 185°F (–40 to 85°C)
Operating temperature: –4 to 131°F (–20 to 55°C)
Operating humidity: 10 to 90 percent (non-condensing)
System Memory
32 MB RAM
16 MB flash
Input Power
Requirements
100 to 240 VAC; 50 to 60Hz (power supply)
36 to 57 VDC (device)
Powering Options
Local power
802.3 AF switches
Cisco higher-power switches capable of supporting 13W or greater
Cisco Aironet power injectors (PWRINJ3 and PWRINJ-FIB)
Third-party PoE devices (must meet input power and power draw requirements)
Power Draw 12.95W maximum
Note: 12.95W is the maximum power required at the powered device. If the access point is
being used in a PoE configuration, the power drawn from the power sourcing equipment will
be higher by some amount dependent on the length of the interconnecting cable. This
additional power may be as high as 2.45W, bringing the total system power draw (access point
and cabling) to 15.4W.
Warranty One year
Wi-Fi Certification
System Requirements
Table 3 lists the system requirements for Cisco Aironet 1240AG Series Access Points.
Table 3. System Requirements for Cisco Aironet 1240AG Series Access Points
Access Method Description
Browser Using the Web browser management GUI requires a computer running Internet Explorer
Version 6.0 or later, or Netscape Navigator Version 7.0 or later.
PoE Power sourcing equipment compliant with Cisco inline power or IEEE 802.3af, and providing
at least 12.94W at 48 VDC
To Next Page
Loading...
