11
Step 5 Configure the settings using the following sections as a guide.
• Host Name—The host name (or system name) is a name for the access point that identifies
it on your network. The system name appears in the titles of the management system
pages.
• Configuration Server Protocol—This setting specifies how the access point obtains an IP
address.
–
DHCP—IP address is automatically assigned by the network DHCP server.
–
Static IP—The access point uses a static IP address that you enter in the IP address
field.
• IP Address—This setting assigns or changes the access point IP address. If DHCP is
enabled, the access point obtains its IP address from your network DHCP server. You can
assign a static IP address in this field.
• IP Subnet Mask—The IP subnet mask identifies the subnet on which the access point
resides. This subnet is provided by your network administrator. If DHCP is enabled, leave
this field blank.
To Next Page
Loading...
