11
4. Remove the card from the mini-PCI connector.
For instructions on installing the radio card, go to the “Installing a 2.4-GHz
Radio Card” section on page 13.
Removing a 2.4-GHz Radio Card
Follow these steps to remove a 2.4-GHz radio card from your access point.
Caution The internal access point components and the 2.4-GHz radio
can be damaged by ESD from improper handling.
Caution The antenna connectors can be damaged if you use a pair of
long-nose pliers to remove them.
Caution To avoid damaging the antenna wire assemblies, handle them by
their connectors.
1. Use your fingers to carefully remove the antenna wire connectors from
the 2.4-GHz radio card.
To Next Page
Loading...
