20
Removing a 5-GHz Radio Module
When your access point is configured with a 5-GHz radio module, follow
these steps to remove it:
1. Remove all cables and power connections from the access point. If you
are removing the connectorized antenna version, remove the antenna
cables from the radio module.
2. Place the access point on a flat surface so that it is upright with the front
end facing you.
3. Unscrew the two mounting screws using the supplied T-10
tamper-resistant Torx L-wrench. See the following illustration.
1 Mounting screws 3 Access point
2 5-GHz radio module antenna
74631
1 1 2 3
To Next Page
Loading...
