18
Unpacking the Radio Module
Each 5-GHz radio module is shipped with the following items:
• This quick start guide
• A product registration card
• A T-10 tamper-resistant Torx L-wrench
• A 5-GHz radio product compliance label
If anything is missing or damaged, contact your Cisco representative for
support.
Caution Handle all components carefully and observe all ESD
precautions. The internal access point components and the
5-GHz radio can be damaged by ESD if not handled properly.
Removing the 5-GHz Radio Access Cover
If your access point was configured with a 5-GHz radio, go to the “Removing
the 5-GHz Radio Access Cover” section on page 18. If your access point was
not configured with a 5-GHz radio, follow the steps below to remove the
5-GHz radio access cover:
1. Remove all cables and power connections from the access point.
To Next Page
Loading...
