Cisco Aironet 1815m - Access Point Features

4
Access Point Features
A full listing of the access point's features and specification are provided in the Cisco Aironet 1815m
Access Point Data Sheet, at the following URL:
http://www.cisco.com/c/en/us/products/collateral/wireless/aironet-1815-series-access-points/datashee
t-c78-738499.html
The features of the 1815m access points are:
• Supported mode(s) of operation:
– Unified (or Local)
– Sniffer
– Monitor
– FlexConnect (Flex + Bridge modes and SE connect are not supported)
– Mobility Express
• Radio features supported are:
– 2.4 GHz and 5 GHz concurrent radios
– 2 GHz radio with 2TX x 2RX and two spatial streams SU-MIMO
– 5 GHz radio with 2TX x 2RX 802.11ac Wave 2 capable with two spatial streams SU-MIMO
and MU-MIMO
– Spectrum Analysis
– 802.11ac based Transmit Beamforming
– Quality of Service (QoS)
– Radio Resource Management (RRM)
– Rogue Detection
– BandSelect
– Bluetooth Low Energy 4.0
• The AP supports the following hardware external interfaces:
– One 10/100/1000 BASE-T (Ethernet) Uplink Interface with inline power capability,
Auto-MDIX (automatically support either straight through or crossover cables), and
802.3af/at PoE.
– RS-232 console interface through RJ45
Note The AP may face issues while booting if you use an unterminated console cable (not
plugged into any device or terminal) or a console cable that is more than one meter in
length.