6
Warning
This product relies on the building’s installation for short-circuit (overcurrent)
protection. Ensure that the protective device is rated not greater than:
20A.
Statement 1005
Warning
Do not operate your wireless network device near unshielded blasting caps or in an
explosive environment unless the device has been modified to be especially qualified for
such use.
Statement 245B
Warning
Ultimate disposal of this product should be handled according to all national laws and
regulations.
Statement 1040
Caution The fasteners you use to mount an access point on a ceiling must be capable of
maintaining a minimum pullout force of 20 lbs (9 kg) and must use a minimum of 4 holes
on the mounting bracket, or a minimum of 2 holes when mounting on a network box.
Caution This product and all interconnected equipment must be installed indoors within the same
building, including the associated LAN connections as defined by Environment A of the
IEEE 802.3af/at Standard.
Note This equipment is suitable for use in environment air spaces (plenums) in accordance with
Section 300.22 (C) of the National Electrical Code, and Sections 2-128, 12-010(3) and 12-100
of the Canadian Electrical Code, Part 1, CSA C22.2. External power supply, power adapter
and/or power injector, if provided, are not suitable installation in air spaces.
Note Use only with listed Information Technology Equipment (ITE) equipment. For more
information on ITE equipment, refer to article 645 of the latest National Electrical Code
(NEC).
To Next Page
Loading...
Need help?
General
