Cisco AS5350XM - Page 103

Index
IN-3
Cisco AS5350XM and Cisco AS5400XM Universal Gateways Card Installation Guide
78-17406-01
RJ-45 to Twinax cable A-3
R
removing
carrier card
2-3
CT3 feature card 4-2
dial-only feature card 5-3
T1 or E1 feature card 3-3
universal port feature card 5-3
voice feature card 6-3
required tools and equipment 1-3
restrictions
universal port and dial-only feature cards
5-2
voice feature card 6-2
RX MON bantam jack port 7-10
S
safety
electricity
1-2
ESD wrist strap 1-3
ground connections 1-2
SPE firmware 5-10
symbols
caution
viii
note viii
timesaver viii
tips viii
T
T1 or E1 feature card
8-port T1 or E1 feature card cable pinouts
A-6
attaching the 8-port T1 or E1 feature card interface cable
to a bracket
A-8
cable assemblies A-2
configuring input impedance 3-11
installing 3-9
LEDs (table) 7-3
online insertion and removal 3-2
overview 3-1
removing 3-3
RJ-45 to bare wire cable pinouts (table) A-5
RJ-45-to-BNC cable pinouts (table) A-3
RJ-45-to-DB-15 cable pinouts (table) A-2
RJ-45-to-DB-15 null modem cable pinouts (table) A-2
RJ-45-to-RJ-45 NT cable pinouts (table) A-4
RJ-45-to-RJ-45 T1 cable pinouts (table) A-5
RJ-45-to-RJ-45 TE cable pinouts (table) A-4
RJ-45 to Twinax cable pinouts (table) A-3
verifying input impedance 3-12
timesaver symbol, meaning of viii
tips symbol, meaning of viii
tools required 1-3
troubleshooting 7-1
displaying environment status 7-8
drop and insert mode for the CT3 feature card 7-10
LEDs 7-1
mix of universal port and dial-only feature cards 7-6
mix of voice feature cards with universal port and
dial-only feature cards
7-6
mix of WAN feature cards 7-5
monitoring chassis environment 7-7
network interfaces 7-11
operating temperature 7-7
using bantam jack port 7-10
TX MON, bantam jack port 7-10
U
universal port feature card
installing
5-8
LEDs (table) 7-5
mixing with dial-only feature card 7-6
online insertion and removal 5-3
overview 5-1
removing 5-3