EasyManuals Logo

Cisco ASA 5545-X Cli Configuration Guide

Cisco ASA 5545-X
2164 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1005 background imageLoading...
Page #1005 background image
1-11
Cisco ASA Series CLI Configuration Guide
Chapter 1 Configuring Management Access
Configuring ICMP Access
Guidelines and Limitations
This section includes the guidelines and limitations for this feature.
Context Mode Guidelines
Supported in single and multiple context mode.
Firewall Mode Guidelines
Supported in routed and transparent firewall mode.
IPv6 Guidelines
Supports IPv6.
Additional Guidelines
• The ASA does not respond to ICMP echo requests directed to a broadcast address.
• The ASA only responds to ICMP traffic sent to the interface that traffic comes in on; you cannot
send ICMP traffic through an interface to a far interface.
• If you cannot ping the ASA interface, make sure that you enable ICMP to the ASA for your IP
address using the icmp command.
Default Settings
By default, you can send ICMP packets to any ASA interface using either IPv4 or IPv6.

Table of Contents

Other manuals for Cisco ASA 5545-X

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco ASA 5545-X and is the answer not in the manual?

Cisco ASA 5545-X Specifications

General IconGeneral
Power SupplyDual, Hot-swappable
Memory8 GB
Flash Memory8 GB
AC Input Voltage100-240 VAC
Form Factor1 RU
Number of VLANs1024
Security Contexts50
Interfaces8 x Gigabit Ethernet
Frequency50-60 Hz
Dimensions (H x W x D)1.75 x 17.5 x 12 in (4.4 x 44.5 x 30.5 cm)
High AvailabilityActive/Standby
StorageSSD (optional)

Related product manuals