Data-MDTBGP-ADOpaque-valueNameProfile
Number
PIM or BGP-AD
(knob controlled)
•
Intra-AS MI- PMSI
•
S- PMSI for
Data-MDT
Type 2 -
RootAddresss:VPN -
ID:0 -n
Rosen MLDP with
BGP -AD
9
LSP-switch for P2MP-TE
Turnaround for P2MP-TE can be handled by LSP-switch with a partitioned profile. For partitioned profiles,
there is no core tree (where all the PEs join). When the traffic arrives at the ingress PE, it is forwarded to the
RP-PE on a LSP. The RP-PE must then switch the traffic to a different LSP for all the non-RP PE receivers.
Configuration Process for MLDP MVPN (Intranet)
These steps provide a broad outline of the different configuration process of MLDP MVPN for intranet:
For detailed summary of the various MVPN profiles, see the Summary of Supported MVPN Profiles, on
page 36.
Note
•
Enabling MPLS MLDP
◦
configure
◦
mpls ldp mldp
•
Configuring a VRF entry
◦
configure
◦
vrf vrf_name
◦
address-family ipv4/ipv6 unicast
◦
import route-target route-target-ext-community
◦
export route-target route-target-ext-community
•
Configuring VPN ID
◦
configure
◦
vrf vrf_name
◦
vpn id vpn_id
The configuring VPN ID procedure is needed for profiles 1 and 9 (Rosen MLDP).
•
Configuring MVPN Routing and Forwarding instance
Cisco ASR 9000 Series Aggregation Services Router Multicast Configuration Guide, Release 5.1.x
37
Implementing Layer-3 Multicast Routing on Cisco IOS XR Software
Label Switched Multicast (LSM) Multicast Label Distribution Protocol (mLDP) based Multicast VPN (mVPN) Support
To Next Page
Loading...
