Cisco ASR 9001-S Hardware Installation Guide

5-5
Cisco ASR 9001 and Cisco ASR 9001-S Routers Hardware Installation Guide
OL-26701-02
Chapter 5 Replacing Cisco ASR 9001 Router Components
Removing a Chassis from the Equipment Rack
Figure 5-2 Removing or Installing an AC or DC Power Module
Installing an AC or DC Power Module
To install an AC or DC power module (see Figure 5-2):
Step 1 Slide the power module into the bay until it mates with its backplane connector.
Step 2 Make sure that keying lever locks with the chassis.
Step 3 Verify that the OK (green) power indicator on the front of the power module comes ON. If the indicator
does not light up, see the “Troubleshooting the Power Subsystem” section on page 4-3.
Removing a Chassis from the Equipment Rack
Use this procedure to remove the chassis and its components from the equipment rack:
Warning You must use two people to remove the chassis from the equipment rack safely. An empty chassis can
weigh up to approximately 24.69 pounds (11.2 kg) .
Step 1 Power off the router (see the “Powering Off the Router” section on page 5-2).
Step 2 Power off the circuit breakers to the power supplies.
332383

Cisco ASR 9001-S Specifications

General

Brand	Cisco
Model	ASR 9001-S
Category	Network Router
Language	English