Cisco ASR 9001 Installation Guide

Figure 20: Cisco ASR 9006 Router Clearance Requirements for an Enclosed 4-Post Rack Installation
Cisco ASR 9010 Router Clearance Requirements
To install a Cisco ASR 9010 Router in a 4-post enclosed cabinet:
• The front and rear doors of the cabinet must be removed or be perforated with a minimum open area of
65 percent (70 percent for 800-mm racks).
• Ensure that you have the following clearances around the chassis:
• Rear: Minimum of 3.15 inches (8.00 cm) of clearance.
• Sides: Minimum of 2.87 inches (7.28 cm) of clearance on each side of the chassis.
This figure shows the side and rear chassis air-flow clearance requirements for mounting the Cisco ASR 9010
Router in a 4-post enclosed rack.
Cisco ASR 9000 Series Aggregation Services Router Hardware Installation Guide
20
Preparing for Installation
Cisco ASR 9010 Router Clearance Requirements

Cisco ASR 9001 Specifications

General

Router Series	ASR 9000 Series
Rack Units	2 RU
Operating System	Cisco IOS XR
Form Factor	Rack-mountable
Power Supply	AC or DC
Memory	8 GB
Forwarding Capacity	Up to 80 Gbps
Switching Capacity	160 Gbps
Operating Temperature	0 to 40°C
Weight	24 lb
Redundancy	Power supply