Cisco ASR 920 series Configuration Guide

PurposeCommand or Action
Example:
Router> enable
•
Enter your password if prompted.
Enters global configuration mode.configure terminal
Example:
Router# configure terminal
Step 2
Manually triggers VLAN load balancing on the segment.
rep preempt segment segment-id
Step 3
Example:
Router(config)# rep preempt segment 1
•
Enter the segment ID.
You will be asked to confirm the action before the
command is executed.
Note
Returns to privileged EXEC mode.end
Example:
Router(config)# end
Step 4
Displays the REP topology information.show rep topology
Example:
Router# show rep topology
Step 5
Configuring SNMP Traps for REP
You can configure the router to send REP-specific traps to notify the Simple Network Management Protocol
(SNMP) server of link operational status changes and any port role changes.
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
snmp mib rep trap-rate value
4.
end
5.
show running-config
6.
copy running-config startup-config
LAN Switching Configuration Guide Cisco IOS XE Everest 16.5.1 (Cisco ASR 900 Series)
25
Configuring Resilient Ethernet Protocol
Configuring SNMP Traps for REP

Cisco ASR 920 series Specifications

General

Form Factor	1RU
Operating System	Cisco IOS XE
Model	ASR 920 series
Memory	4 GB DRAM
Power Supply	AC or DC
Storage Temperature	-40°C to 70°C (-40°F to 158°F)
Relative Humidity	5% to 95% non-condensing
MTBF	Varies by model
Management	CLI, SNMP