Cisco ASR 920 series Configuration Guide

PurposeCommand or Action
Sets the revision level of the MSTP region.
revision revision -number
Example:
Device(config-mstp)#)revision 1
Step 6
Returns to privileged EXEC mode.end
Example:
Device(config-mstp-if)# end
Step 7
Configuring untagged EFP over MST interface
Describes steps to configure untagged EFP over MST:
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
interface interface number
4.
no ip address
5.
service instance number ethernet [name]
6.
bridge-domain bridge-id
7.
encapsulation untagged dot1q {any|vlan-id [,vlan-id [-vlan-d]]}
8.
l2protocol peer stp
9.
end
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode.enable
Example:
Router> enable
Step 1
Enters global configuration mode.configure terminal
Example:
Router# configure terminal
Step 2
Specifies the Gigabit Ethernet interface to configure, where:
slot/subslot/port-Specifies the location of the interface.
interface interface number
Example:
Router(config)# interface gigabitEthernet 0/0/5
Step 3
LAN Switching Configuration Guide Cisco IOS XE Everest 16.5.1 (Cisco ASR 900 Series)
71
Multiple Spanning Tree Protocol
Configuring Multiple Spanning Tree Protocol

Cisco ASR 920 series Specifications

General

Form Factor	1RU
Operating System	Cisco IOS XE
Model	ASR 920 series
Memory	4 GB DRAM
Power Supply	AC or DC
Storage Temperature	-40°C to 70°C (-40°F to 158°F)
Relative Humidity	5% to 95% non-condensing
MTBF	Varies by model
Management	CLI, SNMP