Cisco Catalyst 2960-XR Reference

debug platform remote-commands
To enable debugging of remote commands, use the debug platform remote-commands command in privileged
EXEC mode. To disable debugging, use the no form of this command.
debug platform remote-commands
no debug platform remote-commands
Syntax Description
This command has no keywords or arguments.
Command Default
Debugging is disabled.
Command Modes
Privileged EXEC
Command History
ModificationRelease
This command was introduced.Cisco IOS 15.0(2)EX1
Usage Guidelines
The undebug platform remote-commands command is the same as the no debug platform
remote-commands command.
When you enable debugging on a switch stack, it is enabled only on the stack master. To enable debugging
on a stack member, you can start a session from the stack master by using the session switch-number privileged
EXEC command. Enter the debug command at the command-line prompt of the stack member. You also can
use the remote command stack-member-number LINE privileged EXEC command on the stack master switch
to enable debugging on a member switch without first starting a session.
Related Commands
DescriptionCommand
Monitors all or specified stack members.
remote command
Accesses a specific stack member from the stack master.
session
Catalyst 2960-XR Switch Stack Manager Command Reference, Cisco IOS Release 15.0(2)EX1
14 OL-29435-01
Stack Manager Commands
debug platform remote-commands

Cisco Catalyst 2960-XR Specifications

General

Stacking Bandwidth	80 Gbps
Layer Support	Layer 2 and Layer 3
Jumbo Frame Support	9198 bytes
RAM	512 MB
Input Voltage	100-240V AC
Model	Catalyst 2960-XR
Uplink Interfaces	4 x 1G SFP or 2 x 10G SFP+
Downlink Interfaces	24 or 48 x Gigabit Ethernet ports
Power Supply	Internal
MAC Address Table Size	16, 000 entries
PoE	Available on PoE models
Weight	4.5 kg
Features	energy efficiency
Stacking	Up to 8 switches
Operating Temperature	0 to 45°C