show platform stack manager
To display platform-dependent switch-stack information, use the show platform stack manager command
in privileged EXEC mode.
show platform stack manager {all| counters| trace [cs [cs]| sdp [reverse]| state [reverse]| tdm]}
Syntax Description
Displays all information for the entire switch stack.all
Displays the stack manager counters.counters
Displays trace information.trace
(Optional) Displays information about changes in stack-related trace messages.cs
(Optional) Displays Stack Discovery Protocol (SDP) information.sdp
(Optional) Displays trace information in reverse chronological order (from recent to
older chronological sequence).
reverse
(Optional) Displays stack state machine information.state
(Optional) Displays information about topology discovery including a summary of
the stacking over Ethernet state machine events and messages.
tdm
Command Default
None
Command Modes
Privileged EXEC
Command History
ModificationRelease
This command was introduced.Cisco IOS 15.0(2)EX1
Usage Guidelines
Use this command only when you are working directly with your technical support representative while
troubleshooting a problem. Do not use this command unless your technical support representative asks you
to do so.
This command is supported only on stacking-capable switches.Note
The summary information about the switch stack shows these states:
Catalyst 2960-XR Switch Stack Manager Command Reference, Cisco IOS Release 15.0(2)EX1
OL-29435-01 27
Stack Manager Commands
show platform stack manager
To Next Page
Loading...
Need help?
General
