Cisco Catalyst 2960-XR

remote command
To monitor all or specified stack members, use the remote command privileged EXEC command.
remote command {all| stack-member-number} LINE
Syntax Description
Applies to all stack members.all
The stack member. The range is 1 to 8.
stack-member-number
The command to execute.
LINE
Command Modes
Privileged EXEC
Command History
ModificationRelease
This command was introduced.Cisco IOS 15.0(2)EX1
Usage Guidelines
The commands that you use in the LINE command-to-execute string (such as debug, show, or clear) apply
to a specific stack member or to the switch stack.
Examples
This example shows how to execute the undebug command on the switch stack:
Switch(config)# remote command all undebug all
Switch :1 :
------------
All possible debugging has been turned off
Switch :5 :
------------
All possible debugging has been turned off
Switch :7 :
------------
All possible debugging has been turned off
This example shows how to execute the debug udld event command on stack member 5:
Switch(config)# remote command 5 undebug all
Switch :5 :
------------
UDLD events debugging is on
Related Commands
DescriptionCommand
Reloads the stack member and applies a configuration change.
reload
Displays information related to the stack member or the switch stack.
show switch
Catalyst 2960-XR Switch Stack Manager Command Reference, Cisco IOS Release 15.0(2)EX1
OL-29435-01 19
Stack Manager Commands
remote command