1-13
Catalyst 2960 Switch Getting Started Guide
OL-9368-03
Chapter 1 Getting Started Guide
Rack-Mounting
Warning
If a redundant power system (RPS) is not connected to the switch, install an RPS
connector cover on the back of the switch.
Statement 265
Warning
Class 1 laser product.
Statement 1008
Warning
For connections outside the building where the equipment is installed, the
following ports must be connected through an approved network termination
unit with integral circuit protection: 10/100/1000 Ethernet.
Statement 1044
Warning
Warning Voltages that present a shock hazard may exist on Power over Ethernet
(PoE) circuits if interconnections are made using uninsulated exposed metal
contacts, conductors, or terminals. Avoid using such interconnection methods,
unless the exposed metal parts are located within a restricted access location
and users and service people who are authorized within the restricted access
location are made aware of the hazard. A restricted access area can be
accessed only through the use of a special tool, lock and key or other means of
security.
Statement 1072
To Next Page
Loading...
