K
Kristina RoseJul 31, 2025
What to do if Express Setup does not run on Cisco CATALYST 2960 Switch?
- BBrandon LongJul 31, 2025
If Express Setup on your Cisco Switch isn't running, first ensure POST ran successfully. The SYST and STAT LEDs should be green before you press the Mode button to enter Express Setup. If you pressed the Mode button during POST, wait for it to complete, power cycle the switch, and then try again. Also, make sure all LEDs above the Mode button are green (RPS LED should be off). If your PC has a static IP address, temporarily switch to DHCP before connecting to the switch.