Cisco CATALYST 2960

2-249
Catalyst 2960 Switch Command Reference
78-16882-01
Chapter 2 Catalyst 2960 Switch Cisco IOS Commands
show access-lists
show access-lists
Use the show access-lists privileged EXEC command to display access control lists (ACLs) configured
on the switch.
show access-lists [name | number | hardware counters | ipc] [ | {begin | exclude | include}
expression]
Syntax Description
Note Though visible in the command-line help strings, the rate-limit keywords are not supported.
Command Modes Privileged EXEC
Command History
Usage Guidelines The switch supports only IP standard and extended access lists. Therefore, the allowed numbers are only
1 to 199 and 1300 to 2699.
This command also displays the MAC ACLs that are configured.
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
are not displayed, but the lines that contain Output are displayed.
Examples This is an example of output from the show access-lists command:
Switch# show access-lists
Standard IP access list 1
10 permit 1.1.1.1
20 permit 2.2.2.2
30 permit any
40 permit 0.255.255.255, wildcard bits 12.0.0.0
Standard IP access list videowizard_1-1-1-1
name (Optional) Name of the ACL.
number (Optional) ACL number. The range is 1 to 2699.
hardware counters (Optional) Display global hardware ACL statistics for switched and
routed packets.
ipc (Optional) Display Interprocess Communication (IPC) protocol
access-list configuration download information.
| begin (Optional) Display begins with the line that matches the expression.
| exclude (Optional) Display excludes lines that match the expression.
| include (Optional) Display includes lines that match the specified expression.
expression Expression in the output to use as a reference point.
Release Modification
12.2(25)FX This command was introduced.