Cisco CATALYST 2960

B-7
Catalyst 2960 Switch Command Reference
78-16882-01
Appendix B Catalyst 2960 Switch Debug Commands
debug dot1x
debug dot1x
Use the debug dot1x privileged EXEC command to enable debugging of the 802.1x feature. Use the no
form of this command to disable debugging.
debug dot1x {all | errors | events | packets | registry | state-machine}
no debug dot1x {all | errors | events | packets | registry | state-machine}
Syntax Description
Note Though visible in the command-line help strings, the redundancy keyword is not supported.
Command Default Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug dot1x command is the same as the no debug dot1x command.
Related Commands
all Display all 802.1x debug messages.
errors Display 802.1x error debug messages.
events Display 802.1x event debug messages.
packets Display 802.1x packet debug messages.
registry Display 802.1x registry invocation debug messages.
state-machine Display state-machine related-events debug messages.
Release Modification
12.2(25)FX This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled. For
syntax information, see the Cisco IOS Release 12.2 Configuration Guides
and Command References > Cisco IOS Configuration Fundamentals
Configuration Guide, Release 12.2 > System Management >
Troubleshooting and Fault Management.
show dot1x Displays 802.1x statistics, administrative status, and operational status for
the switch or for the specified port.