Cisco CATALYST 2960

B-33
Catalyst 2960 Switch Command Reference
78-16882-01
Appendix B Catalyst 2960 Switch Debug Commands
debug platform matm
debug platform matm
Use the debug platform matm privileged EXEC command to enable debugging of platform-dependent
MAC address management. Use the no form of this command to disable debugging.
debug platform matm {aging | all | ec-aging | errors | learning | rpc | secure-address | warnings}
no debug platform matm {aging | all | ec-aging | errors | learning | rpc | secure-address |
warnings}
Syntax Description
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug platform matm command is the same as the no debug platform matm command.
Related Commands
aging Display MAC address aging debug messages.
all Display all platform MAC address management event debug messages.
ec-aging Display EtherChannel address aging-related debug messages.
errors Display MAC address management error messages.
learning Display MAC address management address-learning debug messages.
rpc Display MAC address management remote procedure call (RPC) related debug
messages.
secure-address Display MAC address management secure address learning debug messages.
warning Display MAC address management warning messages.
Release Modification
12.2(25)FX This command was introduced.
Command Description
debug matm Displays information about platform-independent MAC address management.
show debugging Displays information about the types of debugging that are enabled. For syntax
information, select Cisco IOS Release 12.2 Configuration Guides and
Command References > Cisco IOS Configuration Fundamentals
Configuration Guide, Release 12.2 > System Management >
Troubleshooting and Fault Management.