Cisco CATALYST 2960 Getting Started Guide

CHAPTER
1-1
Catalyst 2960 Switch Getting Started Guide
OL-9368-03
1
Getting Started Guide
About This Guide
This guide provides instructions on how to use Express Setup to initially
configure your Catalyst switch. Also covered are switch management options,
basic rack-mounting procedures, port and module connections, power connection
procedures, and troubleshooting help.
For additional installation and configuration information for Catalyst 2960
switches, see the Catalyst 2960 documentation on Cisco.com. For system
requirements, important notes, limitations, open and resolved bugs, and
last-minute documentation updates, see the release notes, also on Cisco.com.
When using the online publications, refer to the documents that match the
Cisco
IOS software version running on the switch. The software version is on the
Cisco IOS label on the switch rear panel.
For translations of the warnings that appear in this publication, see the Regulatory
Compliance and Safety Information for the Catalyst 2960 Switch guide.

Cisco CATALYST 2960 Specifications

General

Manageable	Yes
Stacking	No
Model	Catalyst 2960 Series Switches
Power over Ethernet (PoE)	Available on some models (IEEE 802.3af)
VLANs	255 active VLANs
Features	QoS
Operating Temperature	32 to 113°F (0 to 45°C)
Relative Humidity	10% to 85% non-condensing
Power Consumption	Varies by model (30W to 400W)